€69.99

A submersible phone case that attaches to handlebars, and to helm bars on yachts, our Aquapac Bike Mounted Waterproof Phone Case is perfect for iPhones up to and including iPhone 6.

+ Read more - Compress
share this
  • Description
    • No tools required – designed to be attached with your fingers only
    • You’ll be able to talk and hear through it without a problem
    • and your touchscreen will work normally
    • It’s not just 100% waterproof – it’ll protect your phone from dust, dirt and sand too
    • You won’t necessarily have to buy a new one when you upgrade your phone, because it’s a generic rather than a form-fit case (unlike a hard case, it’s not tailored to a specific device).

    Bike-Mount Instructions 

    No tools are required.

    Unscrew the bike mount, place on the bar and screw back together in the required position.

    Insert the case with the Aquaclip seal at the bottom.

    Pull it down till it locks into place.

    You can use the case vertically or horizontally.

    To remove it turn it upside down and then you can pull it up out of the mount.

  • Specifications
    • This case is 100% PVC-free. It is made of a special TPU which is thin enough for you to use your touchscreen, but still remarkably strong.
    • The seams are high-frequency welded to form a super-strong bond.
    • The Aquaclip® seal opens and closes with a quick twist of two levers. And everything stays in one piece even when it’s open.
    • Caution: It’s not foolproof. If you’re not careful you could get a hole in the case, or let water in when opening it. But as long as you treat it sensibly and carefully it should give you many years of use.

     

  • Reviews

    Leave your review

    The fields marked with an asterisk (*) are required.

  • Expert Advice
    • Some phones will float in this case and some won’t – make sure you test yours in a basin before you launch it into the sea!
    • Capacitive touchscreens don’t work underwater, the water breaks the circuit. But you can use the volume buttons to operate your camera underwater.
    • Fingerprint recognition such as Apple’s Touch ID won’t work through the Aquapac – you will have to enter your passcode.
    • Some phones have rather sharp edges. The use of a thin bumper case will protect both phone and case.
    • Closing the Case
      Make sure that all parts are properly attached. Wipe away any grit or sand, which could hamper the seal. Always turn the levers as far as they will go. They should lock smoothly, if not there may be something impeding the seal.

      Opening the Case
      Never open your Aquapac in or under water. In order to stop any water getting in when you are opening it, first shake off any water then dry with a towel. Hold the case with the opening at the bottom as you open it.

  • Tell a Friend
  • Ask a Question
stay updated